The keys h, j, k, and l, right under your fingertips, will move the cursor:

You can also use the cursor arrow keys (, , , ), + and - to go up and down, or the RETURN and BACKSPACE keys, but they are out of the way, and the arrow keys are not supported by all terminals. At first, it may seem awkward to use letter keys instead of arrows for cursor movement. After a short while, though, you'll find it is one of the things you'll like best about vi—you can move around without ever taking your fingers off the center of the keyboard.

Before you move the cursor, press ESC to make sure that you are in command mode. Use h, j, k, and l to move forward or backward in the file from the current cursor position. When you have gone as far as possible in one direction, you hear a beep and the cursor stops. For example, once you're at the beginning or end of a line, you cannot use h or l to wrap around to the previous or next line; you have to use j or k.[6] Similarly, you cannot move the cursor past a tilde (~) representing a line without text, nor can you move the cursor above the first line of text.

[6]vim version 4.x, and vim version 5.x with nocompatible set, allow you to "space past" the end of the line to the next one with l or the spacebar.

You can precede movement commands with numbers. Figure 2.2 shows how the command 4l moves the cursor four spaces to the right, just as if you had typed l four times (llll).

Figure 2.2. Multiplying commands by numbers

The ability to multiply commands gives you more options and power for each command you learn. Keep it in mind as you are introduced to additional commands.

When you saved the file practice, vi displayed a message telling you how many lines are in that file. A line is not necessarily the same length as the visible line (often limited to 80 characters) that appears on the screen. A line is any text entered between newlines. (A newline character is inserted into the file when you press the RETURN key in insert mode.) If you type 200 characters before pressing RETURN, vi regards all 200 characters as a single line (even though those 200 characters visibly take up several lines on the screen).

As we mentioned, vi has an option that allows you to set a distance from the right margin at which vi will automatically insert a newline character. This option is wrapmargin (its abbreviation is wm). You can set a wrapmargin at 10 characters:

This command doesn't affect lines that you've already typed. We'll talk more about setting options in Chapter 7. (This one really couldn't wait!)

If you do not use vi's automatic wrapmargin option, you should break lines with carriage returns to keep the lines of manageable length.

Two useful commands that involve movement within a line are:

0

Move to beginning of line.

$

Move to end of line.

In the example below, line numbers are displayed. (Line numbers can be displayed in vi by using the number option, which is enabled by typing :set nu in command mode. This operation is described in Chapter 7.)

The number of logical lines (3) does not correspond to the number of visible lines (6) that you see on the screen. If the cursor were positioned on the d in the word delete, and you entered $, the cursor would move to the period following the word them. If you entered 0, the cursor would move back to the letter m in the word move, at the beginning of line two.

You can also move the cursor by blocks of text: words, sentences, paragraphs, etc. The w command moves the cursor forward one word at a time, counting symbols and punctuation as equivalent to words. The line below shows cursor movement by w:

You can also move by word, not counting symbols and punctuation, using the W command. (You can think of this as a "large" or "capital" Word.)

To move backward by word, use the b command. Capital B allows you to move backward by word, not counting punctuation.

We'll discuss movement by sentences and by paragraphs in Chapter 3. For now, practice using the cursor movement commands that you know, combining them with numeric multipliers.